GolfWorks Golf Club Grip Rib Pack & Alignment Plugs by The GolfWorks at Norwalk Foundation. MPN: GW0017. Hurry! Limited time offer. Offer valid only while supplies last. The GolfWorks Rib Pack allows you to correctly align and easily install a rib inside any golf grip creating a ''reminder'' that will guarantee correct
Product Description & Reviews
The GolfWorks Rib Pack allows you to correctly align and easily install a rib inside any golf grip creating a "reminder" that will guarantee correct and consistent hand placement on every club in your bag. Pre-installing the rib onto the golf shaft allows for the grip logo to be installed in any position (logo up or logo down) depending on the golfers preference. Each rib is .035" thick which is slightly less than the USGA .040" maximum allowable rib thickness. Two alignment plugs, one for steel and one for graphite shafts, are included in pack to eliminate the chance of miss-aligning the rib during installation. Simply set the face angle into the required position while inserted into a grip clamp and install the plug with the center alignment stripe at 90º. Once the alignment plug is installed simply rotate the club 180º in the grip clamp until the alignment strip is again at 90º. Peel the paper from the back of the rib to expose the adhesive and attach the rib onto the butt end of the golf shaft. Each rib features a printed alignment line to further ensure the rib is installed correctly. Each rib is .035" thick, .25" wide and 9" in length. Each Rib Pack contains two alignment plugs and 30 individual golf grip ribs.
Features & Highlights
- Grip ribs ensure consistent hand placement on every club, rib can be placed at any position on the shaft allowing for strong, neutral or week grip positions.
- Grip logos can be positioned up or down with rib installed.
- Rib can be installed in any rubber/cord, undersize, standard and oversize grip. Much easier to install correctly vs. ribbed grips
- .035" thickness is close to but not exceeding USGA limit of .040".
- 30 ribs per pak, Alignment plugs included
Have questions about this item, or would like to inquire about a custom or bulk order?
If you have any questions about this product by The GolfWorks, contact us by completing and submitting the form below. If you are looking for a specif part number, please include it with your message.
mpn: GRT, ean: 0852674684914,
A handy item to have in any sized shop, this tool removes most grips for re-use. Didn't cut the shaft short enough? Need to add a counterweight? The grip wasn't aligned straight? These are just some of the reason why you would need to save what could...
By The GolfWorks
mpn: GRIPKIT, ean: 0636875031698,
GolfWorks Grip Golf Club Gripping KitGolfWorks Grip Kit includes a golf grip size gauge, 4oz. grip solvent, 13 pre-cut tape strips and a rubber golf shaft clamp.. Golf grips not included.. ...
Multiple surface patterns with different lines are strategically located at front and backside to ensure a secure grip. The upper portion is more textured, featuring vertical lines and V-line grooves for traction and all-weather control. The lower po...
By The GolfWorks
mpn: GW0115, ean: 0636875031544,
Golfworks Spiral Fluted Reamers Golf Club Hosel Bore ToolMade of high strength steel for longer life, these precision Spiral Fluted Reamers will remove debris and small amounts of metal from virtually any hosel bore.. 1 Spiral Fluted Reamer Bit .370"...